What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 02.07.2025 10:55
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Why does everyone hate Ed Sheeran so much?
But… the neutral is now “floating” because of the 1 ohm resistance.
This is where this question deviates from being a 'generic' question, and becomes more specific.
One is “what exactly is in a ‘surge protector’ ? ”
Marines in LA as ICE protests spread to more U.S. cities: In photos - Axios
These devices are installed between the “hot” and “neutral” and protective ground.
the problem then depends on "how fast does the fuse operate?".
2024–10–14 [Omar Gharbi Omar Gharbi ]
'Mum's young-onset dementia is 'heartbreaking' says Bristol woman - BBC
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
At least they know the answer if they wanted it.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This device then solves the entire problem.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Potential measles exposure in Bernalillo, Sandoval and Santa Fe counties - KOAT
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Barnstars:
Simone Biles calls Riley Gaines 'sick' over criticism of transgender athletes - NBC News
One
Edit 2024–10.
but this device (an Inductor) … impedes the rapid changes in the current.
Boston Red Sox rookie ‘revelation’ made ‘huge’ throw before walkoff - MassLive
Upvotes:
He then describes Rainy Season and Lightning.
First Sentence:
Pedro Sánchez torpedoes Nato unity on eve of crucial summit - Financial Times
This is where the MOV conducts again, and dissipated the energy.
The MOV will conduct when the voltage exceeds 50% of line voltage.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Watch toddler’s joyful scream when beloved uncle surprises him during hide-and-seek - USA Today
nine
A circuit breaker is similar, but is resettable.
At one ohm, the resistor has a maximum of 1 watt power.
What is your review of House of the Dragon, season 2, episode 8, "The Queen Who Ever Was"?
What does a fuse do?
A fuse is a non-resetable over current circuit protector.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
It also is a device that limits the change in current flow.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
So, the voltage could go up to 500 volts, and the fuse will not open up.
(Dc diagram shown, AC is similar).
a photo is worth a thousand words.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–10[John johnson John Johnson ]
eight
This is 'the assistant's answer'
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
but I think this circuit , shows a few more pieces.
What is lightning?
He then describes the function of a fuse.
Because the load is inductive, the current lags the voltage.(by a bit).
Now when you have a certain ac resistance, then a current flows in a loop.
I post the exact comment here.
The other is “what does a “fuse” do?”
2024–10–16 [ OO OLAOYE OYEBODE ]
The third is lightning and “how it gets conducted into a home.”
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
For this case there are devices called Metal oxide varistors (MOV).
[image of Common-mode choke]
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
These are simplified answers to the original question, and does not change anything I wrote above.
what exactly is a ‘surge’ protector?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
An AC voltage/ current source, and an ac inductive load.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
But it can get overloaded, and no longer works.
The bolt then partially travels down the line to your home.
This one hit behind the barn.
There are two important concepts here.
[old diagram got deleted by accident]
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
It seems Mohan does not understand the difference between a comment and an Answer.
Here is a simplified AC power diagram.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
There are three different concepts here that are getting confused.
He then asserts :
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
In schematic diagrams this is the symbol for a fuse:
so, what happens?